This Article Applies From:
CVI Fusion 6.13
Infinity Client 6.13
Infinity Module --
Core Services --
DeMeter --
CVI Net Web --


Introduction

The following article explains how to configure a Desoutter CVIxII series tool controller so that it can be controlled by an Infinity Client station. It also covers the correct asset to use in your Pivotware process and the advanced settings available for working with the CVIxII.


Contents

1  Controller Configuration

2  Fusion Configuration

2.1  Asset Configuration

2.2  Step Configuration

3  Feature Management


Controller Configuration  

The Desoutter CVIxII series controller is capable of being controlled by an integrating party however it is necessary to make some small changes to the configuration in order to define the correct way of working.


See below for which changes are required in a CVIxII controller in order to allow remote control by Infinity Client.


The following CVIxII tool settings have been set directly using the CVIxII keypad


By default, CVIxII controller do not respond to Open Protocol control, as a result, it must be activated on the controller. To activate it:


Station parameters must be set to allow for remote control:

  • With the controller turned on, push the "Esc" button
  • Navigate to "PARAMETERS > STATION > STATION PARAM."
  • Set "Cyc. Src" to Protocol

  • Set "Tool En." to Protocol

  • Set "Stop Sp.En=0" to FALSE

  • Click "Valid"
  • Ensure that the stations IP address is contactable by Infinity


Fusion Configuration  

Asset Configuration  

Setting Up the Asset

In Asset Manager, create a new asset

  • Define a name for your tooling asset.
  • Choose the following properties:

- Asset Type = Tool

- Asset Vendor = Desoutter

- Device Type = CVIxII

  • Define the IP Address of your CVIxII tool controller
  • Define the Port used for the Open Protocol communication to and from your tightening unit you are configuring.
  • Associate your asset to your desired Infinity Client station.

All other options within the asset properties are optional however we suggest filling is as much as possible while you're here.



Advanced Settings
  • Send identifier (UID) at step start = Defines if Infinity sends the cycle's UID to this asset at the start of Action Tool steps using this asset.
  • No event acknowledge (No Ack Flag) = Defines where No Ack Flag in Open Protocol Communication is required or not.

For information about how to create assets and associate assets to stations, please see here


Step Configuration  

  • Click an Action Tool step on your station where the CVIxII has been associated as a local asset.
  • Navigate to the bottom of step properties, expand the Tool Properties sub-menu.
  • In "Available Assets" select your CVIxII asset.
  • Define the Pset that should be selected

For information about how your Action Tool displays and operates on Infinity Client then please see here


Feature Management 

From version 7.0 onward, features within the Pivotware software are required to be activated individually. For more information about Feature management, see here


The Infinity Base feature is always required for the Infinity Client application to run. Any other listed features must be additionally activated in order to use the functionality described in this article:

Infinity BaseStandard Tool